In Part Editor, we created a pocket in the back and cut it .4" deep. Now that the component is here we discovered we only need the pocket .260" deep. Geometry is correct. We cannot find a way to just change the depth of the cut without recreating the whole geometry and specifying new depth. Are we missing something? Seems like there should be a way.
Thanks in advance for the help.
Edit pocket depth
Moderators: Mike Iubelt, Jason Susnjara, Larry Epplin, Clint Buechlein, Mike Iubelt, Jason Susnjara, Larry Epplin, Clint Buechlein
-
Tommy Wieler
- Senior Member
- Posts: 124
- Joined: Fri, Sep 22 2017, 7:49AM
- Company Name: Silverpine Cabinets
- Country: CANADA
Re: Edit pocket depth
What I often do in this case is just manually change the daylight value of the pocketing tool at the machine. For example, to cut the pocket 1/2 inch deeper, add 1/2 inch to the daylight value of the pocketing tool. Just don't forget to change it back when you're done 
-
Kerry Fullington
- Wizard Member
- Posts: 4764
- Joined: Mon, May 09 2005, 7:33PM
- Company Name: Double E Cabinets
- Country: UNITED STATES
- Location: Amarillo, TX
Re: Edit pocket depth
Rob,
Take your cabinet to the cabinet editor,
select the part you want to edit and take it to the constraint manager
place a depth constraint on the geometry you want to change and the edit that constraint.
Take your cabinet to the cabinet editor,
select the part you want to edit and take it to the constraint manager
place a depth constraint on the geometry you want to change and the edit that constraint.
Re: Edit pocket depth
Kerry, I owe you one! Been on CM page 1000s of times and never knew that existed. Just always been X-Y constraints. This will prove very helpful in future. I was today old when I learned this.
