fin to wall toe board
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal, Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal
-
Jack Duren
- Junior Member
- Posts: 44
- Joined: Mon, Apr 10 2006, 3:41PM
- Location: Odessa, MO
fin to wall toe board
I have a finished left cabinet with a right wall end. I have a frame hangs over 1/2 on the wall end, but unable to extend the toe to match. Simple fix?
-
Jack Duren
- Junior Member
- Posts: 44
- Joined: Mon, Apr 10 2006, 3:41PM
- Location: Odessa, MO
-
Joe Soto
- Guru Member
- Posts: 367
- Joined: Thu, May 19 2005, 7:50PM
- Company Name: Fancyridge Wood Products LLC
- Location: Greensburg, Ky
Re: fin to wall toe board
Set the right scribe of the toe kick to -.5 plus whatever your side material thickness is. You will have to cut the toe notch deeper manually or with the part editor. Just for future reference you will probably get more responses quicker if you post questions like this in the software area.
-
Jack Duren
- Junior Member
- Posts: 44
- Joined: Mon, Apr 10 2006, 3:41PM
- Location: Odessa, MO
Re: fin to wall toe board
Not sure where you are seeing this option?
-
Jack Duren
- Junior Member
- Posts: 44
- Joined: Mon, Apr 10 2006, 3:41PM
- Location: Odessa, MO
Re: fin to wall toe board
think I'm getting it..
-
Jack Duren
- Junior Member
- Posts: 44
- Joined: Mon, Apr 10 2006, 3:41PM
- Location: Odessa, MO
Re: fin to wall toe board
Thx... Working out one problem at a time.
On to problem number two.
On to problem number two.
