Vacuum Randomly Turns Off
Moderators: Mike Iubelt, Jason Susnjara, Larry Epplin, Clint Buechlein, Mike Iubelt, Jason Susnjara, Larry Epplin, Clint Buechlein
-
Perry Shimwell
- New Member
- Posts: 2
- Joined: Wed, Apr 26 2023, 12:37PM
- Company Name: Bowwood Cabinet Systems
- Country: CANADA
Vacuum Randomly Turns Off
We recently had an issue where the vacuum pumps lose pressure partway through a sheet. Usually turning the dial on the CNC off and on again fixes it, so likely not a leak or a faulty vacuum pump. It goes from 20-25 HG to 0, so the router stops and we have to reset it. Does anyone know what this could be? Can't see any disconnected hoses or anything, thinking it could be a sensor/electronics issue or something... thanks in advance!!
-
Perry Shimwell
- New Member
- Posts: 2
- Joined: Wed, Apr 26 2023, 12:37PM
- Company Name: Bowwood Cabinet Systems
- Country: CANADA
Re: Vacuum Randomly Turns Off
Just to update, I think problem is the switch on the cnc because turning it off and then back on makes it work, as well as just pushing the dial in hard 