Can't nest this job

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal

Post Reply
Denis L'Heureux
Guru Member
Posts: 406
Joined: Tue, May 17 2005, 12:41PM
Location: In the Boonies near Oromocto, NB, Canada

Can't nest this job

Post by Denis L'Heureux »

I have this small job, 8 cabinets, that I can't nest. It won't nest from the room layout nor will it from the batch cabinet. I hope I have attached the job OK. If anything else is needed, please let me know.
(3.78 MiB) Downloaded 11 times
Clint Buechlein
Thermwood Team
Posts: 702
Joined: Fri, May 15 2015, 1:21PM
Company Name: Thermwood Corp

Re: Can't nest this job

Post by Clint Buechlein »


This sounds goofy, but the "window" is causing the issue. The issue will be fixed for the next version of eCabinets. When nesting, eCabinets sees that part first, sees that it is Alternate Source then stops looking for other parts.

Post Reply