Can't nest this job
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal, Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal
-
Denis L'Heureux
- Guru Member
- Posts: 407
- Joined: Tue, May 17 2005, 12:41PM
- Location: In the Boonies near Oromocto, NB, Canada
Can't nest this job
I have this small job, 8 cabinets, that I can't nest. It won't nest from the room layout nor will it from the batch cabinet. I hope I have attached the job OK. If anything else is needed, please let me know.
- Attachments
-
- Sister.esj
- (3.78 MiB) Downloaded 711 times
-
Clint Buechlein
- Thermwood Team
- Posts: 785
- Joined: Fri, May 15 2015, 1:21PM
- Company Name: Thermwood Corp
- Country: UNITED STATES
Re: Can't nest this job
Denis,
This sounds goofy, but the "window" is causing the issue. The issue will be fixed for the next version of eCabinets. When nesting, eCabinets sees that part first, sees that it is Alternate Source then stops looking for other parts.
-Clint-
This sounds goofy, but the "window" is causing the issue. The issue will be fixed for the next version of eCabinets. When nesting, eCabinets sees that part first, sees that it is Alternate Source then stops looking for other parts.
-Clint-
