Feed override with handheld
Moderators: Mike Iubelt, Jason Susnjara, Larry Epplin, Clint Buechlein, Mike Iubelt, Jason Susnjara, Larry Epplin, Clint Buechlein
-
Scott Marshburn
- Guru Member
- Posts: 862
- Joined: Sat, Mar 05 2011, 7:29AM
- Company Name: Heritage WoodWorks
- Country: UNITED STATES
- Location: Jacksonville Nc
- Contact:
Feed override with handheld
Can we use the handheld to control the feed override
Yes! Oh Yes! I Think We Are Going to make It!
https://www.youtube.com/user/ecabinetstips
https://www.facebook.com/groups/397563664342467
https://www.youtube.com/user/ecabinetstips
https://www.facebook.com/groups/397563664342467
-
Clint Buechlein
- Thermwood Team
- Posts: 753
- Joined: Fri, May 15 2015, 1:21PM
- Company Name: Thermwood Corp
- Country: UNITED STATES
Re: Feed override with handheld
Scott,
Depends. If you are using the handheld that has the wheel on it for pulse control, no. If it is any of the others (G56, G57, T20E), then yes. Those have a Feed 0% button to set it to zero, then a Feed %+ and Feed %- buttons to adjust the feed rate up and down. Pressing Shift the Feed %+ will change the feed increment, how much the feed rate changes with each button press. Options are 1%, 5%, 10%, and 20%.
-Clint-
Depends. If you are using the handheld that has the wheel on it for pulse control, no. If it is any of the others (G56, G57, T20E), then yes. Those have a Feed 0% button to set it to zero, then a Feed %+ and Feed %- buttons to adjust the feed rate up and down. Pressing Shift the Feed %+ will change the feed increment, how much the feed rate changes with each button press. Options are 1%, 5%, 10%, and 20%.
-Clint-