the drill bits allow me to overide the depth of the cut to go past what the tool lenght sensor detects. it would be nice if there was an option for every bit to do this.
I use tongue and grove option and use the depth of the cut as adjustment for the fit to be tighter or looser, being able to adjust the depth of the cut on that particular bit would allow me to adjust the fit on the bit itself.
bit specific height adjustment
Moderators: Mike Iubelt, Jason Susnjara, Larry Epplin, Clint Buechlein, Mike Iubelt, Jason Susnjara, Larry Epplin, Clint Buechlein
-
Michel Leblanc
- New Member
- Posts: 10
- Joined: Fri, Sep 02 2022, 10:23AM
- Company Name: Extreme Kitchens
- Country: CANADA
-
Forrest Chapman
- eCabinets Beta Tester
- Posts: 1254
- Joined: Mon, May 30 2005, 2:26PM
- Location: Anderson SC.
- Contact:
Re: bit specific height adjustment
You could adjust the daylight for that tool. This will allow you to adjust it while running a program. Keep in mind it will affect every operation that tool is used for.
We use a 3/8 DS for tenon and dado operation so changing the daylight would affect the depth clearance as well but we are talking small numbers here.
Forrest
We use a 3/8 DS for tenon and dado operation so changing the daylight would affect the depth clearance as well but we are talking small numbers here.
Forrest