using drawer box designer

[Chris B Campbell]

Hey All,
I was looking at building a 2 tier drawer box with the top box at 1/2 the width of the main box. This would mean I need a partition for one of the slides. So far have I not found a way to add this partition running down the middle of the box, (back to front). Is this possible?
Could build it as a cabinet but I want the Dovetail's up front.

Thanks Chris

[Kerry Fullington]

Chris,
You could create the joinery (full dado) in the front, back and bottom of your dovetail box and then create and cut the partition separately.