Recently after an update to the software (last week) randomly starting half way through a cut today on sheet 3 I noticed a sticker with Off-Fall $-1$ and I thought cool I just seen it roll over like a cars odometer! Took photos and sent them to a few people all excited.
And then the next sheet, and the sheet after that all have the same barcode and number. I realized it wasn't so cool it was frigged.
Anyone know how to get my Off-Fall ID working again.
NOTE: I tried to attach photos but it won't allow me saying file is too large. Phone won't take low-res photos
Can you send an export from Control Nesting to program@thermwood.com with Attn Clint - From Forum as the subject? I'll need to reproduce it here to make to give the software engineers something to look at.
