Constraint manager request
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal, Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal
-
Forrest Chapman
- eCabinets Beta Tester
- Posts: 1260
- Joined: Mon, May 30 2005, 2:26PM
- Location: Anderson SC.
- Contact:
Constraint manager request
It would be nice if we had an option to shift/select multiple constaints and make equal.
-
Forrest Chapman
- eCabinets Beta Tester
- Posts: 1260
- Joined: Mon, May 30 2005, 2:26PM
- Location: Anderson SC.
- Contact:
Re: Constraint manager request
The option to snap to center of geometry would be great too!
-
Clint Buechlein
- Thermwood Team
- Posts: 785
- Joined: Fri, May 15 2015, 1:21PM
- Company Name: Thermwood Corp
- Country: UNITED STATES
Re: Constraint manager request
I know I've thought of it before, but I can't remember if I've added it as a request so I'll get it added. I would see this as using CTRL to select multiple, then choose Edit, Edit Constraint and you can modify them to a value. The dialog would likely populate with the last selection by default. Then again I'm not a programmer so I dunno.Forrest Chapman wrote: Sun, Mar 08 2026, 1:19PM It would be nice if we had an option to shift/select multiple constaints and make equal.
I'll add it too, its one of those easier said than done though as that point doesn't exist right now as a whole. All those calculations then have to backtracked through so so much. Same thing again, I'm not a programmer so maybe its easy.Forrest Chapman wrote: Sat, Apr 04 2026, 8:27AM The option to snap to center of geometry would be great too!
-Clint-
