control nesting buggy

Discuss Thermwood 3-axis Machinery, Controller, and Software.

Moderators: Mike Iubelt, Jason Susnjara, Larry Epplin, Clint Buechlein, Mike Iubelt, Jason Susnjara, Larry Epplin, Clint Buechlein

Post Reply
Arthur Ledet
Junior Member
Posts: 34
Joined: Sat, Jan 14 2006, 3:32PM
Location: New Orleans

control nesting buggy

Post by Arthur Ledet »

when i nest a job it shows me what sheets i have etc i print them out so i know what it is cutting on what sheet. then i go to sheet six on this particiular jod and it is back panels to the cabinets and it it giving me drilling operations. it should only be doing two dados then outlining the pieces. also when i select a sheet it says that the call label doesn't exist. tks in advance.

Arthur
Cabinets and Countertops of Louisiana
(504)464-7039
Top
User avatar
Thom Davies
Guru Member
Posts: 530
Joined: Tue, May 17 2005, 6:44PM
Company Name: Dawn Group
Country: NEW ZEALAND
Location: Christchurch New Zealand

Post by Thom Davies »

Which RN are you running on?

Thanks

Thom Davies
Top
User avatar
Brian Shannon
eCabinets Beta Tester
Posts: 979
Joined: Thu, May 19 2005, 10:50PM
Location: Los Alamos, CA

Post by Brian Shannon »

I had that same message while attempting to do my flip operations the following day. I was using RN 4.89. I just noticed that 4.90 is now available.
Top
Post Reply

Return to “Thermwood 3-Axis Machinery”