V6 Save error

[Terry Davis]

After removing vent holes from the side of a previously drawn cabinet by right clicking and selecting "remove part editor cuts from selected part" I try to save and I get "AN ERROR OCCURRED WHILE ADDING HOOPS INFORMATION TO THE SAVE FILE".

[Josh Rayburn]

Scott (if you are still alive this week, hope you are feeling better) - This sounds strangely familiar to some of the issues we were talking about last week on the phone....In case it's any help...
Terry, my issue eventually was resolved by making some changes to a temp file hidden away in a directory somewhere - and we suspected it may have been interfered with by third party software (my backup software from Western Digital) but you may want to wait for a TWD response before you try that.

Scott and I spoke at length to try to rectify the same problem, but we weren't convinced that we had a definite cause.
jnr

[Scott G Vaal]

Terry,

Can you reproduce this a second time? Also, can you save one of the V6 standard cabs and get the same error? Can you please post the original cabinet you are working with and I will see if I can reproduce it.

[Terry Davis]

Scott,
It only does it with my ver 5 cabinets, tried it with a new v6 and it saved fine, I will post my v5 cabinet.