Barbed tool not found
Moderators: Mike Iubelt, Jason Susnjara, Larry Epplin, Clint Buechlein, Mike Iubelt, Jason Susnjara, Larry Epplin, Clint Buechlein
-
DanFecteau
- eCabinets Beta Tester
- Posts: 278
- Joined: Tue, May 10 2005, 12:00PM
- Location: St-Odilon, Quebec, Canada
- Contact:
Barbed tool not found
I was ready to machine a job with barbed dado but when I write the cnc program I get : Barbed dado between x and x size not found ??? How do I set a barbed dado tool, I tought I just had to put in the 1/4" downcut diameter tool and that was it. I use 5.59, is 5.6 been released ?? Thanks for your quick reply, I'm ready to machine !
-
Forrest Chapman
- eCabinets Beta Tester
- Posts: 1260
- Joined: Mon, May 30 2005, 2:26PM
- Location: Anderson SC.
- Contact:
Re: Barbed tool not found
In tool settings there is description box for the tool being used. You need to enter "barbed" in this box.
Forrest
Forrest
