Constraint Manager Question
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal, Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal
-
Scott Marshburn
- Guru Member
- Posts: 864
- Joined: Sat, Mar 05 2011, 7:29AM
- Company Name: Heritage WoodWorks
- Country: UNITED STATES
- Location: Jacksonville Nc
- Contact:
Constraint Manager Question
This is probably a $25 question but what are the Circular Quadrant nodes in constraint manager used for?
Yes! Oh Yes! I Think We Are Going to make It!
https://www.youtube.com/user/ecabinetstips
https://www.facebook.com/groups/397563664342467
https://www.youtube.com/user/ecabinetstips
https://www.facebook.com/groups/397563664342467
-
Kerry Fullington
- Wizard Member
- Posts: 4735
- Joined: Mon, May 09 2005, 7:33PM
- Company Name: Double E Cabinets
- Country: UNITED STATES
- Location: Amarillo, TX
Re: Constraint Manager Question
Scott,
I use them to constrain the radius on arched valances, or top rails. you can also use the to constrain the radius on fillets etc.
I use them to constrain the radius on arched valances, or top rails. you can also use the to constrain the radius on fillets etc.