Flip Parts in CN 5.74

[Georgi Baltov]

I am getting flip operations on a G2S parts that only have machining operations on one side. Is anyone else getting the same thing. The issue started with CN 5.74. The same cabinet was run on 5.73 with no issue. I've attached it to the post. The pocket on the drawer fronts are machined as flip.

[Daniel Vonderheide]

Georgi,

You have the two lower drawer slabs in a group with the upper drawer front. This upper drawer front has drill holes on the back side of it. Because they are grouped and there is machining on both sides of the parts in the group, Control Nesting is setting the pockets as the flip operation instead of the drill holes. If you ungroup the parts, they nest without any flip operation.

[Georgi Baltov]

Can I delete my post? Haha.

Daniel, sorry for wasting your time.