Problem with nesting editor
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal, Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal
-
Donald L Estes
- New Member
- Posts: 9
- Joined: Mon, Nov 07 2011, 8:22PM
- Company Name: Estes Constr + Woodwrkg
- Country: UNITED STATES
Problem with nesting editor
When i've nested or optimized a cabinet the nest report jumps off the top of the screen, I can right click and drag the Header panel down back into view, but when I try to print the nest job or nested sheets the print area is half off the top of page. How do I fix this?
-
Daniel Odom
- Senior Member
- Posts: 204
- Joined: Thu, Oct 20 2011, 12:52PM
- Company Name: Carlton Kitchen and Bath
- Country: UNITED STATES
Re: Problem with nesting editor
Have you tried adjusting your print settings?
-
Donald L Estes
- New Member
- Posts: 9
- Joined: Mon, Nov 07 2011, 8:22PM
- Company Name: Estes Constr + Woodwrkg
- Country: UNITED STATES
Re: Problem with nesting editor
I have tried adjusting print settings , no change
