Good afternoon.
Anybody from South Africa still hanging around on this forum? If so, where do you get your cutters from? Leuco has take over the Onsrud sales in SA, but if you contact them to order cutters they do not even understand the term up-cut or downcut. They have one! diamond cutter in this hole country.
Thanks in advance.
Marius
CNC Cutters
Moderators: Mike Iubelt, Jason Susnjara, Larry Epplin, Clint Buechlein, Mike Iubelt, Jason Susnjara, Larry Epplin, Clint Buechlein
-
Marius Gouws
- Junior Member
- Posts: 82
- Joined: Sun, May 14 2006, 4:01AM
- Company Name: Plett Roofing
- Country: SOUTH AFRICA
- Location: Plett, South Africa
- Contact:
-
jason galbraith
- Senior Member
- Posts: 249
- Joined: Wed, Dec 10 2008, 3:29PM
- Company Name: Eastcoast Ultimate
- Country: AUSTRALIA
- Contact:
Re: CNC Cutters
Sounds like a market opening for a knowledgeable tools salesperson over there.
Core i7-2600 @ 3.70Ghz - 8 GB ram - Win 7 Ultimate 64bit - 2 x 24" ASUS monitors - Nvidia 600 Quadro 1GB graphics
www.eastcoastultimate.com.au
www.eastcoastultimate.com.au
-
Neville Bastian
- Guru Member
- Posts: 622
- Joined: Fri, May 20 2005, 6:48PM
- Company Name: Classic Cabinetry
- Location: Albany Western Australia
- Contact:
Re: CNC Cutters
Hey Jason you better not write that advert.
I have had a few tools work for me over the years but not sure if they would make good cutter salesman?
Marius best of luck with a better source of product supply. We have paid high dollars for tooling over the years to find a lower cost one out performs it by over half.
Regards
Neville
I have had a few tools work for me over the years but not sure if they would make good cutter salesman?
Marius best of luck with a better source of product supply. We have paid high dollars for tooling over the years to find a lower cost one out performs it by over half.
Regards
Neville
Neville Australia