Hi from OZ.
I have just created a simple 45deg chamfer tool to cut a mitred edge on the end of a panel.
When i select the tool iget a dialog box saying closing tool selection dialog. then it just takes me back
to the previous screen. how do i overcome this problem ?
Thanks in advance John.
tool creation problem
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal, Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal
-
John Powell
- Senior Member
- Posts: 114
- Joined: Thu, Dec 29 2005, 3:14AM
- Location: Perth Western Australia
tool creation problem
Nearly is not enough
