Turn Off 'Show Hole Patterns'

Nat Wheatley · Post by **Nat Wheatley** » Wed, Feb 18 2015, 4:36PM

I can't seem to turn off this option and keep it off. It turns back on when I go back and forth between editing areas.

Nat Wheatley · Post by **Nat Wheatley** » Sat, Feb 21 2015, 3:43PM

Anyone?

tim lucas · Post by **tim lucas** » Sat, Feb 21 2015, 10:29PM

Nat, I tried and it seemed to stay turned off while in cabinet editor between modules but if I return to the room and come back it resets.
Is that what you mean?
Tim

Nat Wheatley · Post by **Nat Wheatley** » Sun, Feb 22 2015, 6:53AM

Tim, what you've described actually is what it's doing. Sorry for the confusion.

Nat

tim lucas · Post by **tim lucas** » Sun, Feb 22 2015, 7:55AM

I don't see a way can turn it off permanently either

Thermwood / eCabinet Systems

Turn Off 'Show Hole Patterns'

Turn Off 'Show Hole Patterns'

Re: Turn Off 'Show Hole Patterns'

Re: Turn Off 'Show Hole Patterns'

Re: Turn Off 'Show Hole Patterns'

Re: Turn Off 'Show Hole Patterns'