How to edit cabinets in this assembly??

[markvan]

I am trying to edit the cabinets in this assembly I downloaded from the customer 3d section of the forums. (Stanisci W Series hood)

http://www.thermwood.com/forums/viewtop ... sci#p69186

I can't figure out how to do it !?!

When I bring it to the cabinet/assembly editor, click on a cabinet, it only selects the individual part I click on. (a single gable, the door or back etc...) How do I select the whole cabinet so I can edit sizes or add crown mouldings etc.? Not sure what I'm doing wrong...

Thanks!
Mark.

*Edit* ---- Figured out I just have to double click....!

[Clint Buechlein]

Double click to select a whole cabinet. You can then make your changes you need to, to that particular cabinet. If you double click another cabinet, you cannot make any changes. Only one can be selected at a time to make changes. You can either double click on the cabinet again to deselect, or press escape.

-Clint-

[markvan]

Thanks for speedy reply. Just figured that out!