So I've been trying to Predrill my hinge holes on my cabinet but it just makes a small dot on the material I tried editing the hardware hole and change the negative thickness/Positive thickness but nothing changed any help please?
~Nick
HardWare Holes
Moderators: Jason Susnjara, Jason Susnjara
-
Nicholas Kiss
- Junior Member
- Posts: 31
- Joined: Wed, Nov 22 2017, 2:09PM
- Company Name: Clearcut
- Country: CANADA
-
Brad McIntosh
- Guru Member
- Posts: 539
- Joined: Wed, May 18 2005, 6:59PM
- Company Name: CNC Automation
- Country: CANADA
- Location: St. Zotique, Québec, Canada
- Contact:
Re: HardWare Holes
Nicholas,
After modifying the pattern in the Hardware Hole Editor, did you "reapply" the doors? If not, the old pattern is saved with that cabinet and the "disk copy" is not considered in any rebuild.
Contact Jim here at CNC Automation if you need some assistance.
After modifying the pattern in the Hardware Hole Editor, did you "reapply" the doors? If not, the old pattern is saved with that cabinet and the "disk copy" is not considered in any rebuild.
Contact Jim here at CNC Automation if you need some assistance.
