Control nesting to settings glitch or not question

[Mark McCallum]

Hi Guys
Is this happening to any one else?
We’re using control nesting 6.07
1 load job
2 loaded material list comes up. just accept (OK)
2 nest x or y
3 go to settings Via settings icon (Don’t do anything or do something doesn’t matter)
4 click OK
Setting dialog closes and returns to Control Nesting, It tries to recalculate but gets stuck. (spinning wheel)
The only way out is to close the control nesting non-responding program.


To stop it happening, its best to close control nesting then reopen, don't load any job, open settings check or do whatever you have to do then reload the job.
Thanks
Mark

[Clint Buechlein]

Hi Guys
Is this happening to any one else?
We’re using control nesting 6.07
1 load job
2 loaded material list comes up. just accept (OK)
2 nest x or y
3 go to settings Via settings icon (Don’t do anything or do something doesn’t matter)
4 click OK
Setting dialog closes and returns to Control Nesting, It tries to recalculate but gets stuck. (spinning wheel)
The only way out is to close the control nesting non-responding program.


To stop it happening, its best to close control nesting then reopen, don't load any job, open settings check or do whatever you have to do then reload the job.
Thanks
Mark

Mark,

Next version of Control Nesting should have this corrected. Should be this week when we release.

-Clint-

[Mark McCallum]

Thanks Clint

[Clint Buechlein]

Mark,

Today's release of Control Nesting should correct this. Link to install http://www.thermwood.com/updates_contro ... g_home.htm.

-Clint-