Hi everybody
I was trying to nest a job but when it's pocketing, the CN freezes forever. I have to restart the computer a few times but the issue remains. Could you plz tell me why?
thanks
kim
pocketing error while nesting
Moderators: Mike Iubelt, Jason Susnjara, Larry Epplin, Clint Buechlein, Mike Iubelt, Jason Susnjara, Larry Epplin, Clint Buechlein
-
Mark McCallum
- Guru Member
- Posts: 539
- Joined: Thu, Jun 16 2005, 7:53PM
- Location: Sydney Aust
Re: pocketing error while nesting
Hi Dang
I have not much idea about your machine, but sometimes on our machine, if I forget to check our tools or tool group for the loaded materials, it gets to the point where it needs the tool, (perhaps in your case the designated pocketing tool ) and just stops.
We have to either,
load that tool in, and restart the sheet,
Or change an existing tool to pocketing and remove the missing tool from that material tool-group and re-nest.
Hope that helps or make sense.
Mark
I have not much idea about your machine, but sometimes on our machine, if I forget to check our tools or tool group for the loaded materials, it gets to the point where it needs the tool, (perhaps in your case the designated pocketing tool ) and just stops.
We have to either,
load that tool in, and restart the sheet,
Or change an existing tool to pocketing and remove the missing tool from that material tool-group and re-nest.
Hope that helps or make sense.
Mark