Suggestion: Inches & Fractions Display To 1/64"

[Vince Lisanti]

I have suggestion for the next build if possible?

Can we please allow the Inches & Fractions display to allow down to 1/64?

Only going to 1/32" is really problematic in the door creation area for cut listing when transferring shaper cutter data into the program.

I know I can use the inches and decimal format and than have excel convert it to fractions, I have been doing this for quite a while.
However, It would be one less step for possible error if we could just get 1/64" in the system.

Thank You