Angled back of cabinet
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal, Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal
-
John J. Desmond
- Senior Member
- Posts: 242
- Joined: Wed, Oct 24 2007, 9:58PM
- Company Name: American Millwork Company
- Country: UNITED STATES
- Location: Joplin, Missouri
Angled back of cabinet
I am needing to do several cabinets that are 10" at the top from front to back and 28" at the bottom from front to back with the back being the angle. Can this be done without taking each cabinet side into part editor?
