Our new machine has the flycut routine which is great but we run 2 waste boards. I know we can get around it by going into settings and changing the waste board thickness back to what it was before but it would be better if there was a checkbox to cut a second waste board at the new setting.
Forrest
Flycut routine request
Moderators: Mike Iubelt, Jason Susnjara, Larry Epplin, Clint Buechlein, Mike Iubelt, Jason Susnjara, Larry Epplin, Clint Buechlein
-
Forrest Chapman
- eCabinets Beta Tester
- Posts: 1260
- Joined: Mon, May 30 2005, 2:26PM
- Location: Anderson SC.
- Contact:
-
Tommy Wieler
- Senior Member
- Posts: 124
- Joined: Fri, Sep 22 2017, 7:49AM
- Company Name: Silverpine Cabinets
- Country: CANADA
Re: Flycut routine request
Our workaround: set the "Amount to remove" to 0 when flycutting the second wasteboard. Quick and easy.
-
Forrest Chapman
- eCabinets Beta Tester
- Posts: 1260
- Joined: Mon, May 30 2005, 2:26PM
- Location: Anderson SC.
- Contact:
Re: Flycut routine request
Yep, makes perfect sense! Thanks
