It would be great if the hardware hole editor allowed patterns created below the x-axis to reference from the top of the front. This would allow us to use a pattern for flipper hinges easily.
It would also be nice if a door allowed for a top hinge too.
While I'm on the subject what about a pattern that will apply to the back of a blind corner panel?
Thanks, Forrest
Hardware hole patterns
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal, Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal
-
Forrest Chapman
- eCabinets Beta Tester
- Posts: 1260
- Joined: Mon, May 30 2005, 2:26PM
- Location: Anderson SC.
- Contact:
