shelf hole drilling

Discuss Thermwood 3-axis Machinery, Controller, and Software.

Moderators: Mike Iubelt, Jason Susnjara, Larry Epplin, Clint Buechlein, Mike Iubelt, Jason Susnjara, Larry Epplin, Clint Buechlein

Post Reply
Forrest Chapman
eCabinets Beta Tester
Posts: 1260
Joined: Mon, May 30 2005, 2:26PM
Location: Anderson SC.
Contact:
Contact Forrest Chapman

shelf hole drilling

Post by Forrest Chapman »

Hello Thermwood,

My router wants to drill four holes on all the sets and then go back and drill the final hole for all the sets. I remember a post a while back but can't find a fix. I'm currently running 4.89 but will upgrade if nessesary.

Forrest
Top
User avatar
Jason Susnjara
Thermwood Team
Posts: 1653
Joined: Tue, May 10 2005, 1:26PM
Location: Thermwood
Contact:
Contact Jason Susnjara

Post by Jason Susnjara »

Hi Forrest,

The programmers are aware of this but I don't think it has been fixed as of yet. The programmers have been busy with V5 but I am sure they will get a new Control Nesting update as soon as they get a chance.
Top
Post Reply

Return to “Thermwood 3-Axis Machinery”