I was trying to set up a spline to handle some curved molding. I recall from 91000 class that we used a program called CAD Path to get a smoother fit. I created my spline and checked all the points and it looked good.
I then ran CAD Path and when I went to test the program I got a \"Z axis out of bounds error\". In looking at the program it switches to absolute coordinates at the point of the spline and the Z values go below the surface of the table. I am not sure what I am missing.
CAD Path
Moderators: Mike Iubelt, Jason Susnjara, Larry Epplin, Clint Buechlein, Mike Iubelt, Jason Susnjara, Larry Epplin, Clint Buechlein
-
Bill OConnell
- Senior Member
- Posts: 121
- Joined: Mon, Jun 13 2005, 12:26PM
- Location: Calverton, New York
- Contact:
CAD Path
- Attachments
-
- SPLINE0706.zip
- Here is the CAD Path version, zipped
- (21.51 KiB) Downloaded 636 times
Woodworking the Way You Want It
-
Brent East
- Thermwood Team
- Posts: 20
- Joined: Tue, Jun 28 2005, 9:19AM
Hi Bill,
This problem could be caused by a number of things. The best way to work through this would to be to contact us here at Thermwood to get this resolved the quickest. Please feel free to call myself at 800-533-6901 or our technical service line at 800-221-3865. Thanks.
Brent East
Product Manager/ Software
Thermwood Corp.
This problem could be caused by a number of things. The best way to work through this would to be to contact us here at Thermwood to get this resolved the quickest. Please feel free to call myself at 800-533-6901 or our technical service line at 800-221-3865. Thanks.
Brent East
Product Manager/ Software
Thermwood Corp.