router is double-drilling

Mark Hesketh · Post by **Mark Hesketh** » Mon, Nov 13 2006, 3:19PM

i posted this in the ecabs forum, but after some more thought, figured it might be a problem with the control nesting software. the problem is that some of my holes will get drilled twice. random holes (as far as i can tell) are having the drill drop twice into them in quick succession. i have only noticed this since upgrading to CN V5.05

is anybody else running into this problem?

Post by **Jason Susnjara** » Mon, Nov 13 2006, 4:16PM

Hi Mark,

I have not encountered this as of yet. Can you send me a cabinet or job so I can take a look at it?

Nick M Singer · Post by **Nick M Singer** » Tue, Nov 14 2006, 12:04AM

Yup I have also got this happening on occasion in V5.04. My drill bank comes down twice, just slightly off from the first drill op.