Dados being treated as pockets

Zach Froble · Post by **Zach Froble** » Sat, Dec 09 2006, 2:41PM

Has anyone ran into this problem before.

All cabinets created in Build 10, and they all have blind dado contruction. They are no part editor cuts on any of them. But when I go to nest in CN 5.08 it is treading all my dados as pockets and it wants that correct diameter of tooling to do so. I have never run into this before and was wondering if any one else has.

Thanks,
Zach

Nick M Singer · Post by **Nick M Singer** » Mon, Dec 11 2006, 6:16AM

Me Too Me too Zach but only when working with DXFs

Zach Froble · Post by **Zach Froble** » Mon, Dec 11 2006, 9:30AM

Nick,

How did you fix this problem. I have 22 cabinets that I need to cut parts for asap, but I haven't found a fix yet.

Zach

Nick M Singer · Post by **Nick M Singer** » Mon, Dec 11 2006, 12:19PM

Hi Zach As I said I have not had the problem with items generated from eCabs. I find most of this comes from not having the material associated with the tooling. Try and add the material to your tool group again sometimes that works

Thermwood / eCabinet Systems

Dados being treated as pockets

Dados being treated as pockets