Doors

Tabatha Yeitz · Post by **Tabatha Yeitz** » Tue, Dec 26 2006, 11:12AM

Just a quick question for you guys. I have about 30 doors & drawers that the guys out in the shop asked me to send to the CNC. No problem, they already have the sizes they want & the way they prefer it to be nested. Is there any way to alter the nesting to make these doors & drawers bookmatched? Please help, the manual is not very helpful or explanatory.
-Tab

Post by **Jason Susnjara** » Thu, Dec 28 2006, 9:37AM

Hi Tabatha,

You can only group a set of doors/drawers on a single cabinet not for an entire run of cabinets. In the cabinet editor you can right click and select Group Parts. Then a box will pop up on the screen and you will then select the doors and drawers you want to group together.

Tabatha Yeitz · Post by **Tabatha Yeitz** » Thu, Dec 28 2006, 9:39AM

Thanks

Thermwood / eCabinet Systems

Doors

Doors