Rollin nest 4.61

Paul Ford · Post by **Paul Ford** » Mon, Jul 25 2005, 3:08PM

Hi all,
Just upgraded to rolling nest 4.61 tried loading a job up which consisted of only 1 cabinet. I then tried to nest a whole job, loaded it pressed ok and then the system froze up. It has done it on a few jobs not just the one.
Any help much appreciated as always
Thanks,
Paul.

Glenn Van Reason · Post by **Glenn Van Reason** » Mon, Jul 25 2005, 9:56PM

Hi Paul,
Yep same here, I tried nesting four jobs together, as we do here and have had no problems till now, and it froze up, It seems to be taking a very long time loading a job for nesting, the bigger the job the longer it takes.
Looks like it can only handle one job at a time. Yes I have restarted, re installed and checked all updates.

Any patches, suggestions work arounds????

Thanks
Glenn

Paul Ford · Post by **Paul Ford** » Mon, Jul 25 2005, 10:19PM

Hi Glenn,
I just went back to v 4.60 until 4.61 is fixed

Glenn Van Reason · Post by **Glenn Van Reason** » Sun, Jul 31 2005, 4:35PM

For anyone seeing this post the fix has been posted on the Thermwood website....Changes/Additions for v4.62 (7/28/05)

Any chance of notification to users of bug fixes when this happens?????
This was reported on here and I sent emails as well, I have recieved no notification of it being looked at or indeed even fixed, just happened to be watching the website and noticed the update.
Someone has to of read about the problem, then fixed it, then posted it, a quick note on this forum wouldn't go astray.

Post by **Jason Susnjara** » Tue, Aug 02 2005, 2:32PM

Hi Paul and Glenn,

Can you send me a job that crashes THM software?

thanks,

Paul Ford · Post by **Paul Ford** » Tue, Aug 02 2005, 2:36PM

Hi Jason,
I have upgraded to V 4.62 and all is working well now.
Thanks,
Paul.