Holes that wont go away!

Thom Davies · Post by **Thom Davies** » Fri, Feb 02 2007, 5:16PM

Hey hows it all going?

I got a cabinet here that when i put 2 partions in and = them up and take the left 1 out the 3mm holes in the deck stay in the deck and wont go away no matter wot. if i go to construion settings and press ok still wont make the holes go way.

Wot would cause this?

Thanks

Thom Davies

Michael RA Greschuk · Post by **Michael RA Greschuk** » Fri, Feb 02 2007, 9:15PM

Thom If you need a work around for this you can take the deck into part editor and delete the holes

Leo Graywacz · Post by **Leo Graywacz** » Fri, Feb 02 2007, 9:36PM

They went away for me. I took your cabinet to the partition/shelf editor and deleted the partition. Then I went back to the main editor and they were gone. Then I went back and I added two partitions and and went to the main editor and there were holes for both partitions. Then I went back into the partition/shelf editor and deleted the 2nd partition and went back to the main editor and the holes were gone. Seems to be working to/for me.

Thermwood / eCabinet Systems

Holes that wont go away!

Holes that wont go away!