V5.23 OffFall issue...

Mathieu Boileau · Post by **Mathieu Boileau** » Wed, Mar 28 2007, 12:18PM

Hi, we just updated Rolling Nest to V5.23 yesterday. So far we've cut one job fine but there were no offfalls, when i try to execute sheet 1 (nested with an OffFall) i get the error \"Program Error 3180 Call Label does not exist.\" I have exported and attached this nest to this post.

Daniel Vonderheide · Post by **Daniel Vonderheide** » Wed, Mar 28 2007, 2:35PM

In your CN settings area under cut parameters, you have NO offfall cuts checked. this means that the machine will not do anything with offfall. I hope this helps.

Mathieu Boileau · Post by **Mathieu Boileau** » Wed, Mar 28 2007, 2:49PM

Yep, right you are, that's what happens when you take 2 days off and others play with your machine hehe thanks!

Sebastien Boileau · Post by **Sebastien Boileau** » Wed, Mar 28 2007, 3:06PM

\" I did'nt do it \"

Mark Hesketh · Post by **Mark Hesketh** » Thu, Mar 29 2007, 6:33AM

i just throw things at people who use the machine while i am not there watching them... but it's not that i don't trust them not to screw it up or anything... really... lol

Thermwood / eCabinet Systems

V5.23 OffFall issue...

V5.23 OffFall issue...