Changing doors in assemblies

[Jason Gooch]

Hi - another issue - I'm attempting to change my slab doors from walnut to mahogany. This is being done on some assemblies. When I make the change, the lower cabinet of the assembly (where the doors are) jumps up halfway overlapping the upper cabinet in the assembly. I have to go into the cabinet editor to realign the cabinets.

Is this a bug, or something I'm doing wrong?

Thanks - Jason

P.S. I attached the job in my previous post, re: changing materials.

[GaryRasberry]

Jason- I'm experiencing the same phenom but it's even happening when working in the cabinet editor. Seems when I edit any cabinet in the assembly in any manner the cabinet jumps up, down or sideways when I return to the cabinet editor. No harm done otherwise though, just a lot of realigning.