New Glitch

Sebastien Boileau · Post by **Sebastien Boileau** » Wed, Apr 25 2007, 2:05PM

When I remove the ajustable shelf holes in the part editor and add edgebanding after the mod, it brings back the removed shelf holes.
P.S. I remove the unnecessary shelf holes in corner cabinets if anyone is wondering why.

Another issue with the edgebanding is with the partitions, there is no selection available for front side on partitions, only top/bottom/back.

Oh here's another

Would it be possible to have a zoom in function while in the part editor?

.....Here's the last one hehe....
Would it be possible to have unlimited \"undo\" function in part editor or any editor for that matter instead of just one?

There we go i'm done

Paul Ellis · Post by **Paul Ellis** » Wed, Apr 25 2007, 3:37PM

Sebastien,
Well at least one of your wishes came true...hehehe
In the part editor you can zoom in by pressing the ctrl key and then draw a square (or rectangular ) with the left button of the mouse over the area you want to zoom in on. To zoom out you press the home key. The smaller the square, the more the zoom factor. You can even zoom in again and again...

Sebastien Boileau · Post by **Sebastien Boileau** » Thu, Apr 26 2007, 9:12AM

Thanks Paul for the tip! Very usefull function.