Good Job on Build 4

Joe Dusel · Post by **Joe Dusel** » Thu, Jul 12 2007, 4:29PM

Many thanks to the Thermwood team for all of their hard work on Build 4!

Joe

Leo Graywacz · Post by **Leo Graywacz** » Fri, Jul 13 2007, 9:14PM

So far a bunch of things seem to work quicker. Like when you bring a cabinet from the design area to the cabinet editor, do your changes, and go back. It used to take a while for it to go back and now it seems quicker.

I was wondering if there were any tricks on making the drawers work quicker. I used to use dovetails, now I use dadoes. I get the same size pieces but it seems just as slow, maybe a little quicker but not much. Any tricks besides not inserting the drawers until you want to get a parts list?

Thanks

Al Navas · Post by **Al Navas** » Sat, Jul 14 2007, 7:11AM

Leo Graywacz wrote:... Like when you bring a cabinet from the design area to the cabinet editor...

NOW I am confused, Leo. What is the "design editor" , as opposed to the Cabinet / Assembly Editor??? Do you mean the Custom Layout area?

PLEASE tell me there is not something in the program that I did not know about...

Thanks!

Al

Leo Graywacz · Post by **Leo Graywacz** » Sat, Jul 14 2007, 8:21AM

Al Navas wrote:
Leo Graywacz wrote:... Like when you bring a cabinet from the design area to the cabinet editor...
NOW I am confused, Leo. What is the "design editor" , as opposed to the Cabinet / Assembly Editor??? Do you mean the Custom Layout area?

PLEASE tell me there is not something in the program that I did not know about... Thanks!

Al

Yes, Custom Layout Area

Michael Yeargain · Post by **Michael Yeargain** » Sat, Jul 14 2007, 4:47PM

Thermwood / eCabinet Systems

Good Job on Build 4

Good Job on Build 4

Re:

Re: