Hardware Hole Patterns

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal, Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal

Post Reply
Joe Dusel
eCabinets Beta Tester
Posts: 1117
Joined: Tue, May 17 2005, 9:40PM
Location: Vista, CA, U.S.A.
Contact:
Contact Joe Dusel

Hardware Hole Patterns

Post by Joe Dusel »

I must have missed an update or something for the hole patterns because most of the hole patterns I have for slides seem to be setup to only drill 3mm deep. For you CNC guys, do you just assume that these hole patterns all need to be checked before using them?

If we find hole patterns that are bogus do we report these as a bug?

Thanks,

Joe
Top
Forrest Chapman
eCabinets Beta Tester
Posts: 1253
Joined: Mon, May 30 2005, 2:26PM
Location: Anderson SC.
Contact:
Contact Forrest Chapman

Post by Forrest Chapman »

Joe,

All the patterns made by Thermwood are 3mm deep. They are basicaly just marker holes. You will need to go thru the pattern and remove whatever holes you deem unnessesary and then highlight the rest and set a new depth (12.5mm?).

Forrest
Top
Post Reply

Return to “eCabinet Systems Software”