Dimensioning Parts

Dave Schmidt · Post by **Dave Schmidt** » Wed, Aug 08 2007, 7:05AM

I would like to show dimensions on a part to locate dado and other related machining processes. Is there a way I can do this on the e-Cabinet system? All input is appreciated.

Dave

DanEpps · Post by **DanEpps** » Wed, Aug 08 2007, 8:04AM

Dave

The nest diagram shows dimensions for parts as well as dadoes, etc.

Dave Schmidt · Post by **Dave Schmidt** » Wed, Aug 08 2007, 9:40AM

Thanks Dan. The sucess of e-Cabinet Systems are with knowledgable people like you. You guys have been a HUGE reason of why in my opinion, make this program so sucessful. KEEP UP THE GREAT WORK!!

mikesand · Post by **mikesand** » Wed, Aug 08 2007, 1:37PM

You can also take a cabinet of part of a cabinet into the LDE and get the measurements there. Sometimes the Nest diagrams are difficult to use for standard machining practices.

Mike