Discuss Thermwood 3-axis Machinery, Controller, and Software.
Moderators: Mike Iubelt, Jason Susnjara, Larry Epplin, Clint Buechlein, Mike Iubelt, Jason Susnjara, Larry Epplin, Clint Buechlein
-
Rob Davis
- Guru Member
- Posts: 351
- Joined: Mon, May 23 2005, 5:43PM
- Location: Indiana
-
Contact:
Post
by Rob Davis »
I am getting the following when I go to write CNC and it started when I updated to build 4. Any ideas?
Error 80090016 during Crypt Acquire Context
-
Pete Riddle
Post
by Pete Riddle »
Rob try this,
Action/s to Correct Problem:
- Run DAO setup from Disk 1 folder on eCab CD
- THMCRYPT.exe from DAO folder eCab CD
Have a good weekend.
-
Rob Davis
- Guru Member
- Posts: 351
- Joined: Mon, May 23 2005, 5:43PM
- Location: Indiana
-
Contact:
Post
by Rob Davis »
Worked, Thanks