Detail room question

Geo Noeth · Post by **Geo Noeth** » Thu, Oct 25 2007, 8:16AM

When placing a cabinet in detail room, somehow it jumped about 8 ft behind the wall (outside the room). Now I cannot see the cabinet when in detail room so I cannot select it to move it back in the room. It is not associated to the wall, so I cannot see it in wireframe mode. Does anyone know how to get out of this?

Kerry Fullington · Post by **Kerry Fullington** » Thu, Oct 25 2007, 8:19AM

Geo
In Detail Room use the ( -) key on your keyboard to zoom out to see the cabinet.
Kerry

Geo Noeth · Post by **Geo Noeth** » Thu, Oct 25 2007, 8:38AM

Sonofagun I didn't know that. That fixed it.

Once again Kerry, many thanks.

Thermwood / eCabinet Systems

Detail room question

Detail room question