controller question
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal, Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal
-
Darren Harvey
- Junior Member
- Posts: 68
- Joined: Fri, Jun 23 2006, 9:01AM
- Location: palm harbor, fl
controller question
i'm trying to nest a bedroom cabinets. the qestion is that i load the program and i get an error message and the controller shuts down. the problem is in the doors are not nesting. i'm using mdf and changing the doors to 3/4 plywood. i've had a problem in loading update 38 so i'm still running on 36.
-
DanEpps
- Wizard Member
- Posts: 5852
- Joined: Thu, Jul 28 2005, 10:18AM
- Company Name: Dan Epps
- Country: UNITED STATES
- Location: Rocky Face GA
Re: controller question
You might have more success on getting an answer if you post this in the Thermwood forum. This forum is for eCabinet software discussions.
