restore profile modeler

Will Williamson · Post by **Will Williamson** » Sun, Apr 06 2008, 8:00AM

Any one know how to restore profile modeler . I deleted 2 tool from my tool group and then closed the software and went to tool manager in super control and made some changes and when I tried to open profile modeler again I got a warning that said( the currently selected too group will be reverted back to generic )and profile modeler will not load .

Joe Soto · Post by **Joe Soto** » Sun, Apr 06 2008, 9:03AM

Will, If a reboot doesn't work, I would try to reinstall the profile modeler patch. http://downloads.thermwood.com/pmv211patch2.exe
Joe

Will Williamson · Post by **Will Williamson** » Sun, Apr 06 2008, 9:31AM

Thanks Joe I tried that but I still have the problem.Quess that is what you get for working on Sunday.

Will Williamson · Post by **Will Williamson** » Sun, Apr 06 2008, 9:37AM

What I need is a restore disc that works . the last time I tried to use the one that came with machine I crashed the hard drive thm replaced the hard drive but no restore disc

Thermwood / eCabinet Systems

restore profile modeler

restore profile modeler

Re: restore profile modeler

Re: restore profile modeler

Re: restore profile modeler