Roll Top Desk

[George Davidson]

My start of SketchUp Roll Top Desk
I woulden of been so long but I had to make my own DXF.It didn't come with DXF

[George Davidson]

Pictures

[George Davidson]

Up date on Roll Top Desk
The file must be to big when I go into just the one roll top desk with out the roll down. I lose alot when I try to change anything
The roll down is 4-STL that is all the STL's that are in the hole cabinet.To me it looks to just be in the Rails and Stiles.
In the pictures I highlighted the 1-stile then highlighted that hols cabinet frame and took it into the frame editor and this is what comes up. Then it will work OK if I close down the roll top desk. Then bring it back in it will do the same thin all over again
I can not get the esa to down load to the forum it tells me time out It tryed a ZIP no luck