CMT Tol file from e-cabinets
I reset them to make it easier for me in my program
CMT Tol file from e-cabinets
Moderators: Jason Susnjara, Clint Buechlein, Jason Susnjara, Clint Buechlein
-
George Davidson
- eCabinets Beta Tester
- Posts: 1585
- Joined: Tue, May 17 2005, 1:16PM
- Location: Norwood Pa.
CMT Tol file from e-cabinets
- Attachments
-
- CMT Tol for E-Cab.zip
- (1.24 MiB) Downloaded 1682 times
-
- CMT Tol File 8-28-09.jpg (60.24 KiB) Viewed 25762 times
-
- CMT Tol File 8-28-09 in File.jpg (80.72 KiB) Viewed 25762 times
-
Rick Palechuk
- Wizard Member
- Posts: 1896
- Joined: Wed, May 18 2005, 7:54PM
- Company Name: Milltech Millworks Ltd.
- Country: CANADA
- Location: Edmonton, Alberta
- Contact:
Re: CMT Tol file from e-cabinets
George, how did you get the J-pegs to show? Can a DXF be used?
-
George Davidson
- eCabinets Beta Tester
- Posts: 1585
- Joined: Tue, May 17 2005, 1:16PM
- Location: Norwood Pa.
Re: CMT Tol file from e-cabinets
I am not sure what you are talking about J-pegs are 
I did get up at 4 today I think I need so sleep
I did get up at 4 today I think I need so sleep-
Rick Palechuk
- Wizard Member
- Posts: 1896
- Joined: Wed, May 18 2005, 7:54PM
- Company Name: Milltech Millworks Ltd.
- Country: CANADA
- Location: Edmonton, Alberta
- Contact:
Re: CMT Tol file from e-cabinets
The picture of each bit... jpg. file.
-
George Davidson
- eCabinets Beta Tester
- Posts: 1585
- Joined: Tue, May 17 2005, 1:16PM
- Location: Norwood Pa.