We have been doing a few beaded face frames using the Kreg jig. Actually works pretty good. What I would like to do is give the cut out/build sheets to the shop with dimensioned F/F centers, in other words I would like to give the shop the center of two mid rails so there's no mistake in were to cut out the 3/8" deep X 2" notches on the stiles. No math for the shop... Make sense??
Tried going from board stock to sheet stock still will only give me the corners to select for dimensions.
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 9 guests