Thermwood / eCabinet Systems

Hello

I was wondering what the secret is to closing a contour in part editor? I am trying to make rounded and arced countertop edges. I am going into the contour and inputting the points for a three point arc, but then when I go back into part editor and try to pocket the contour, it says that it ...

Thank you for your input. I will try this technique.

Shannon

Hi Everyone!

I have been using the Ecabinet design software for about a month, and although I am becoming more and more comfortable, I have one complication that I cannot seem to figure out. I am trying to construct an angled end base cabinet with an angled door front. I am angling the cabinet and ...