Thermwood / eCabinet Systems

Tin thanks for the reply, I down loaded your file and got 4x8 display board, ??
I up loaded my vent hood, it is very crude.
The only way could make it was to use two cabs but I could not find a way to associate the two cabs as one. Can you or someone else improve on the file I uploaded?
tony

6 ...

Tim, Hood 32.jpg is what I mean.
tony

Hi...
Is there a way to slope the top of a vent hood in ecabinet or door ?
tony

Thanks Scott, your cutter worked. I make my cutter radius from a circle so I went back to my cutters and used the three point arc and my cutter also worked.
Guest I won't use a circle that way in my cutters in the future.
tony

Scott, below are the two .tol filers and I did try going to main and back again.
Thanks for taking an interest in my problem and I do like your videos. Please keep them coming.
tony

Changed cutter design as Scott suggest and I could put a profile on bottom edge. Thanks Scott. But....................................
I ran into a problem with putting two different profiles on the same part. Pics below:

A BIT 1.jpg
A BIT 2.jpg
B BIT 1.jpg
B BIT 2.jpg

I switch 'B' bit for ...

Below are the two cutters.

HI, I have a display board (16"x3"x3/4") in the part editor and can't put a single profile on the bottom edge. It cuts off the bottom edge instead.
I can put the profile all the way around or singly on the other three edges, (left, top, right), but not the bottom.
Is it me, the software or hardware ...

I found where I went wrong...

I would like to view the video tutorials off line.
In the directions I am to:

1.Download Adobe Air and install using on screen instructions.
2.Download Air Player to a known directory.
3.Double click the downloaded .AIR file.
4.Click "Install".

I did step one and two but for step three, I get a ...

in the above designer, I can not edit the 'door name' or 'directory' boxes to save my door.
Is there someplace I am to go first before I got to the door/draw front designer so I can save my doors?