G901 Settings Off

Discuss Thermwood 3-axis Machinery, Controller, and Software.

Moderators: Mike Iubelt, Jason Susnjara, Larry Epplin, Clint Buechlein, Mike Iubelt, Jason Susnjara, Larry Epplin, Clint Buechlein

Post Reply
Zach Froble
Senior Member
Posts: 171
Joined: Tue, Jun 21 2005, 3:23PM
Location: Connellsville, PA

G901 Settings Off

Post by Zach Froble »

I adjusted my 901 settings to run some custom mouldings that I had to fixture. My problem now is that even though I changed them back they are not correct. I checked them several times to make sure it took the changes back to my normal.

Thanks,

Zach
Lyndan Designs
Machining and CAD Services
Top
Dave Burtchell
Junior Member
Posts: 98
Joined: Thu, Jun 30 2005, 10:04PM

Post by Dave Burtchell »

Zack,

Don't forget to drop down to the last line and hit the start button, or is it the block step + button? Anyway, if you don't do this, your changes won't be saved. Just a thought.

Dave
Top
Zach Froble
Senior Member
Posts: 171
Joined: Tue, Jun 21 2005, 3:23PM
Location: Connellsville, PA

Post by Zach Froble »

I thought I had already done that, but that evening I went back and tried it again and everything seems to be working fine now. Thanks for the reply though.

Zach
Lyndan Designs
Machining and CAD Services
Top
Post Reply

Return to “Thermwood 3-Axis Machinery”